Loading... Please wait...

404472 Roush Mustang Lowering Spring (2005-2014)

Shop Mustang Parts

Shop This Part Now: Roush Mustang Lowering Spring (2005-2014)

ROUSH 
Lowering Springs Kit
404472
INSTALLATION INSTRUCTIONS 

This spring set will lower your 2010 ROUSH Mustang an additional 15 mm**.

If you are installing this spring set on a stock Mustang GT, you must purchase the ROUSH Front Struts (PN 131018045) and Rear Shocks (PN 131018080) and it will lower the car 28 mm**.

** Measurements may vary depending on vehicle content.

Before installing your ROUSH Performance Product(s), read through the entire installation procedure and check to make sure all items are present. Contact ROUSH Customer Service at 1-800-59-ROUSH, weekdays from 9:00 AM to 5:00 PM EST, with any questions regarding fit, missing parts or instructions that are unclear to you.

WORK SAFELY!

Perform this installation on a good clean level surface for maximum safety and with the engine turned off.

Disassembly

Follow procedures as outlined in the 2010 Ford Service Manual to remove the front and rear coil springs.

Section 204.01 Front Suspension,

Section 204.02 Rear Suspension.

Assembly

Follow procedures as outlined in the 2010 Ford Service Manual to install the front and rear coil springs.

Section 204.01 Front Suspension,

Section 204.02 Rear Suspension.

Assembly notes:

Front

The ROUSH front jounce bumpers must remain on the front struts. Do not remove.

The front spring lower isolator must be removed from the production spring and installed onto the ROUSH spring as shown in Figure 1. The isolator must be installed as pictured with the second coil overlapping the end.

Rear

The Roush rear jounce bumpers must remain on the rear axle. Do not remove.

All installation instructions, images, & descriptions contained within are representative of the manufacturer instructions included with your part upon purchase & are the sole property thereof.
Pure Speed Motorsports practices due diligence in reviewing these instructions for accuracy and recommends consulting a certified professional when installing any aftermarket part or accessory.